Recording From The Radio - Sharp CD-BA3100H Bedienungsanleitung

Recording from the Radio

Before recording:
z When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
z SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
z The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
z For recording, use only normal tapes. Do not use metal or CrO tapes.
E-28 ENGLISH
Listening to the Radio (See page 17.)
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback
only.
1
Tune in to the desired station. (See page 17.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the REC PAUSE (
button.
Recording will be paused.
4
Press the / button on the
main unit or the TAPE 2 but-
ton on the remote control to
start recording.
To interrupt recording:
Press the REC PAUSE ( ) button.
To resume recording, press the /
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Erase-prevention tab of cassette tapes:
z When recording on a cassette tape, make
sure that the erase-prevention tabs are not
removed. Cassettes have removable tabs
that prevent accidental recording or erasing.
z To protect the recorded sound, remove the
tab after recording. Cover the tab hole with
adhesive tape to record on the tape without
the tab.
)
(TAPE 2 ) button.
Side A
Tab of side B Tab of side A