Listening To The Radio - Sharp XL-BB20D Bedienungsanleitung

Listening to the radio

■ Tuning
1
Press the (ON/STANDBY) button to turn the power
on.
2
Press the TUNER [DAB] button (remote control) or
INPUT button (main unit) repeatedly to select FM
Stereo or FM Mono.
3
● Manual tuning:
Press the TUNING (
control) repeatedly to tune in to the desired station.
● Auto tuning:
Press and hold the TUNING (
Scanning will start automatically and the tuner will stop at
the first receivable broadcast station.
Notes:
● When radio interference occurs, auto scan tuning may
stop automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING
( or ) button again.
● When an RDS (Radio Data System) station is tuned
in, the frequency will be displayed first, and then the
RDS indicator will light up. Finally, the station name
will appear.
● Full auto tuning can be achieved for RDS stations
"ASPM", see page 15.
To receive an FM stereo transmission:
● Press the TUNER [DAB] button to select stereo mode.
"ST" indicator will be displayed. "
pear when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER [DAB]
button to extinguish the "ST" indicator. The reception
changes to monaural, and the sound becomes clearer.
or ) button (remote
or ) button.
" and " " will ap-
EN-14
■ Memorising a station
You can store 30 FM stations in memory and recall them
at the push of a button. (Preset tuning)
1
Perform steps 2 - 3 in "Tuning".
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY button to store
that station in memory. If the "MEM" and preset num-
ber indicators disappear before the station is memo-
rised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorised for that pre-
set channel number will be erased.
Note:
The backup function protects the memorised stations for a
few hours should there be a power failure or the AC power
lead become disconnected.
■ To recall a memorised station
Press the PRESET ( or
station.
■ To scan the preset stations
1
Press and hold the PRESET (
preset number flashes. The programmed stations will
be tuned in sequentially, for 5 seconds each.
2
Press the PRESET (
desired station is located.
■ To erase entire preset memory
1
Press the (ON/STANDBY) button to turn the power on.
2
Press the INPUT button (main unit) repeatedly or
TUNER [DAB] button (remote control) to select Tuner
or DAB function.
3
In Tuner or DAB function, press and hold the CLEAR
button (remote control) until "Tuner Clear" or "DAB
Clear" appears.
) button to select the desired
or ) button until the
or ) button again when the