Operation On The Device - Aqua Computer LEAKSHIELD Standalone Betriebs- Und Montageanleitung

LEAKSHIELD
In the event of an alarm, this interface can be used to shut down the computer in
the same way as pressing the power button. A short or long press can be config-
ured.

7. 7. 7. 7. Operation on the device

Operation on the device Operation on the device Operation on the device
The most important functions of LEAKSHIELD can be controlled directly on the de-
vice. A button located at the right side of the LEAKSHIELD silicone illuminated ring
is used to control the menu.
By a short press on the button, it is possible to navigate directly through the display
pages.
If the button is pressed for longer than one second, the menu is displayed.
At this moment, "MENU" appears briefly in the display, followed by the menu
items.
By shortly pressing the key, you can now select between the following items:
SHIELD (mode selection) SHIELD (mode selection) SHIELD (mode selection) SHIELD (mode selection)
Complete protection and detection of leakages. This function can only be used re-
liably after full configuration via the aquasuite!
MONITOR (mode selection) MONITOR (mode selection) MONITOR (mode selection) MONITOR (mode selection)
The system is monitored for leaks by using a low negative pressure. There is no
protection against leakage in this mode.
RELEASE (mode selection) RELEASE (mode selection)
RELEASE (mode selection) RELEASE (mode selection)
The LEAKSHIELD system is switched off. The vacuum is automatically released, and
pressure equalization occurs automatically.
TEST (action) TEST (action)
TEST (action) TEST (action)
In this action, a leak test of the cooling system is enabled. A configurable negative
pressure is generated as a test pressure and then the pressure loss is displayed.
FILL (action) FILL (action) FILL (action) FILL (action)
This action makes it possible to suck coolant into the system. A vacuum of between
250 and 300 mbar is generated for this purpose.
During filling, the water pump must be switched off. Therefore, we recommend fill- - - - During filling, the water pump must be switched off. Therefore, we recommend fill During filling, the water pump must be switched off. Therefore, we recommend fill During filling, the water pump must be switched off. Therefore, we recommend fill
ing while the PC is switched off! ing while the PC is switched off! ing while the PC is switched off! ing while the PC is switched off!
DEAERATION (action) DEAERATION (action)
DEAERATION (action) DEAERATION (action)
This action supports the venting of the system during filling by cyclically generating
and releasing negative pressure.
- 8 - Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1, 37130 Gleichen
aqua computer
© 2021-2024