Requirements For The Operation Of Leakshield - Aqua Computer LEAKSHIELD Standalone Betriebs- Und Montageanleitung

aqua computer
agree to fully indemnify Aqua Computer GmbH & Co. KG for any damages
resulting from such application!
Never touch the membrane on the bottom side of LEAKSHIELD. Damage to
●
the membrane can cause moisture to enter LEAKSHIELD and subsequently
cause the unit to fail. If you notice any damage to the membrane, contact
the Aqua Computer Technical Support
Use only DP Ultra as a coolant
●

3. 3. 3. 3. Requirements for the operation of LEAKSHIELD

Requirements for the operation of LEAKSHIELD
Requirements for the operation of LEAKSHIELD Requirements for the operation of LEAKSHIELD
In order to operate LEAKSHIELD properly, there are some principles to be ob-
served when selecting the cooling system.
LEAKSHIELD can only be used if the maximum pump pressure in the system is less
than 450 mbar than 450 mbar. This is the case for almost all systems with one pump. For systems
than 450 mbar than 450 mbar
with more than one pump, this must be checked accordingly, e. g. by measuring
the pressure.
The second prerequisite is that the tubing is suitable for the required vacuum
As a broad rule, the outer diameter of PVC tubing should be at least 1.5 times the
inner diameter of soft tubing.
For PUR tubing, a factor of 1.2 is usually sufficient. Hardtubes are generally suit-
able. Without information on compatibility, we recommend testing at slightly in-
creased negative pressure and maximum water temperature before use.
The components of the water cooling system have to be suitable for the operation
with LEAKSHIELD as well and have to withstand the necessary negative pressure
permanently. For Aqua Computer products this applies without exceptions. For
products from other suppliers, you have to check this before starting operation! products from other suppliers, you have to check this before starting operation!
products from other suppliers, you have to check this before starting operation! products from other suppliers, you have to check this before starting operation!
For the LEAKSHIELD Standalone version that you have purchased, there is another
requirement that must be met: The connector must be connected to your reservoir
in such a way that water can freely run back from LEAKSHIELD into the air cushion in such a way that water can freely run back from LEAKSHIELD into the air cushion in such a way that water can freely run back from LEAKSHIELD into the air cushion in such a way that water can freely run back from LEAKSHIELD into the air cushion
of the reservoir of the reservoir of the reservoir. Optimally, LEAKSHIELD is located vertically above the reservoir. of the reservoir
It is also important that there is sufficient air volume in the reservoir
ation, there should be at least 100 ml of air in the reservoir.
To ensure safe operation, only coolants of the DP Ultra series
use. Even if many other coolants are certainly trouble-free, we cannot guarantee
the function with these coolants.
Especially coolants with particles are able to clog or even destroy the membrane
of LEAKSHIELD. Under no circumstances should coolants with flammable sub Under no circumstances should coolants with flammable sub- - - -
Under no circumstances should coolants with flammable sub Under no circumstances should coolants with flammable sub
stances be used! stances be used!
stances be used! stances be used!
© 2021-2024
tubing is suitable for the required vacuum tubing is suitable for the required vacuum. tubing is suitable for the required vacuum
The connector must be connected to your reservoir
The connector must be connected to your reservoir The connector must be connected to your reservoir
sufficient air volume in the reservoir. For safe oper- sufficient air volume in the reservoir sufficient air volume in the reservoir
only coolants of the DP Ultra series are approved for only coolants of the DP Ultra series only coolants of the DP Ultra series
Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1, 37130 Gleichen
LEAKSHIELD
pressure in the system is less
pressure in the system is less pressure in the system is less
For
For For
- 5 -