INVENTOR V5MFI-66B Benutzer- Und Installationshandbuch Seite 14

button ：
7 LOCK
Press and hold
response except pressing these two buttons again to disable locking.
5 seconds at 1Hz. Under Lock mode , the remote control is available.
Press the"AUXILIARY FUNCTION" (FUNC.)button on the unit control panel, then press the ADJUST "
and " " button to select the "
Repeat the above procedures to stop the swing operation.
Never adjust the vertical louvers by hand.
For some units, it also can be adjusted by the control panel.
Press the"AUXILIARY FUNCTION" (FUNC. ) button on the unit control panel, then press the ADJUST
" " and " " button to select the "
up and down. Repeat the above procedures to stop the swing operation. When turn off the unit, the
horizontal louvers will automatically closed to prevent dust.
WARNING
air conditioner(for the units with auto swing function).
NOTE:
The starting angle of the horizontal louver should not be too small, otherwise the narrow air outlet
•
Do not set the starting angle of the louvers too small during cooling or drying operation. Otherwise,
•
condensation may occur on the surface of the horizontal louver and cause dew dripping.
During the operation, if the louvers can not swing normally, shut off the unit and unplug for several
•
minutes, then plug it again and restart the operation.
The horizontal louver may slightly vibrate during the operation. This is normal.
•
ƒ „
Page 14
and buttons together to activate lock feature, all buttons will not
" ," " or "
" (or
" feature and the louvers will swing left and right.
) feature and the horizontal louvers will swing
"