Options / Accessories - WIKA 700.02.080 Betriebsanleitung

7. Options / accessories

7. Options / accessories
7.1 Panel mounting flange (only for Model 700.01, see left picture)
The panel mounting flange may be retrofitted by the customer locally.
Alignment of the front ring (A) using the engraved cams in the grooves on the
outside edge of the case. Push the front ring onto the case until it snaps into
position.
7.2 Minimum or maximum drag pointer (see pictures)
The drag pointer (B) serves to monitor and control the minimum or maximum
occurring differential pressure.
7.3 Reed contact Model 851.3 and 851.3.3 (see pictures)
The Reed contacts may be retrofitted and adjusted by the customer locally.
They are fastened by the two screws (D) integrated intp the reed case (C) on
the display case with the corresponding female thread.
A
WIKA Operating instructions differential pressure gauges with piston per ATEX
C
B
D
C
B
GB
D
9