Texas A/S Snow Buster 650E Anleitung Seite 41

Engine Switch
Turn the engine switch to the OFF position
Engine Switch
Using the snow blower

Push the throttle lever to the right (full speed).

Set the chute in the desired ejecting angle using the adjusting lever
Please note: Ensure that there are no people or animals in front of the auger unit or in the direction of
chute discharger (caution: the ejection range may be between 10 and 15 meter from the snow blower).

Use the 6 forward gears (1st gear slow to 6th gear fast) and 2 reverse (R1 and R2) to achieve
the desired working speed.

Note: Select a slower speed for wet heavy snow, and a higher speed for light powdery snow.

Push the left-hand control lever to engage the auger unit.
Please note: The auger unit on the snow blower is secured to the drive shaft using shearing bolts
(Fig. 21 / Item 30). The Shearing bolts will break, if the auger strikes any hard object, this is to prevent
the snow blower from suffering major damage. Do not replace the shearing bolts with normal bolts.
Two spare bolts with nuts are supplied in the package.
Push the right-hand control lever to engage the drive unit and the snow blower will start to move.

Steer the snow blower where you want to clear snow.

Important. If the snow ejection unit becomes blocked: Turn off the engine and wait until the
auger has stopped rotating. Clean the snow ejection unit using the chute cleanout tool.