Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
e) Always use an undamaged clamping flange
of the correct size and shape for the selected
grinding disc. Suitable flanges support the
grinding disc and reduce the risk of disc break-
age. Flanges for cutting discs can be different to
flanges for other grinding discs.
f) Do not use worn grinding discs from larger
power tools. Grinding discs for larger power
tools are not designed for the higher rotational
speeds of smaller power tools and so can
break.
Additional special safety instructions
for abrasive cutting
a) Avoid causing blockages to the cutting disc
or high contact pressure. Do not make any
excessively deep cuts. Overloading the cutting
disc increases the stress and likelihood of tilting
or blocking and thus the possibility of a setback
or a breakage of the grinding tool.
b) Avoid the area in front of and behind the
rotating cutting disc. When you move the cut-
ting disc away from yourself in the workpiece,
it is possible, in the event of a kickback, that the
power tool along with the rotating disc might be
thrown out directly towards you.
b) If the cutting disc jams or you stop working,
switch the tool off and hold it steadily in the
workpiece until the disc has completely stopped
turning. Never attempt to pull a rotating cutting
disc out of a cut. This could lead to kickback.
Identify and remove the cause of the jam.
d) Do not switch the power tool back on while it
is located in the workpiece. Allow the cutting
disc to reach its full speed before you carefully
continue the cut. Otherwise, the disc can jam,
jump out of the workpiece or cause kickback.
e) Support boards or large workpieces to re-
duce the risk of the cutting disc jamming and
causing a kickback. Large workpieces can
bend under their own weight. The workpiece
must be supported on both sides of the disc:
both in the vicinity of the cutting disc and also
at the edge.
f) Be particularly careful when making "pocket
cuts" into existing walls or other obscured
areas. The protruding cutting disc may cut gas
or water pipes, electrical wiring or other objects
that can cause a kickback.
│ GB │ IE
■
26
Safety guidelines for battery
chargers
This appliance may be used by chil-
■
dren aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks. Do not allow
children to use the appliance as a
toy. Cleaning and user maintenance
tasks may not be carried out by chil-
dren unless they are supervised.
To avoid potential risks, damaged
■
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable for indoor use
only.
WARNING!
■
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person.
PWSA 20-Li A1
Werbung
Kapitel
Inhaltsverzeichnis
