Vari CB-80 Bersetzung Der Originalbetriebsanleitung Seite 35

1) Machine frame
2) Handlebars
3) Handlebars mount bolt
4) Wheel drive lever
5) Drive lever
6) Engine revolutions lever
7) Handle
8) Engine
9) Wheel
10) Drive belt cover
Fig. 1: Machine description
Fig. 2: Unwrapping and assembling the machine
1) Sweeping cylinder drive control lever
2) Drive control lever
Fig.3: Controlling elements
STOP:
1
The engine is off.
Used for turning off a started engine

Putting aside the machine

Fuel refilling

Machine transport

MAX:
3
"Hare" position
Engine is running at maximum rpm.
Operating position

Engine cold start at B&S and

VARI XP - 200 engines
Fig. 5: Slower drive – turtle position
Fig. 7: Cover disassembling
Fig. 9: Setting the sweeping cylinder position
1) Collector
2) Lower part of the rod
3) Nut (piece of the rod´s upper part)
4) Upper part of the rod
5) M8 nut
Fig. 10: Collector assembling
Fig. 11: Collector mounting
Fig. 13: Transport position of the collector
Fig. 15: Dust cover assembling
Fig. 17: Sweeping cylinder drive pulley
Fig. 19: Handlebars bowden cables
Fig. 21: Placing the sweeping cylinders gearbox
Fig. 23: Positioning bolts of bowdens and tension pulley
1) Cylinder sweeping brushes drive V-belt
2) Engine – gearbox V-belt
3) Gearbox – drive axle V- belt
Fig. 24: V-belt route and guiding pins
1) Drive V-belt
2) Right wheel
3) Left wheel
Fig. 25: Replacement of the drive V-belt
Fig. 26: Sticker – speed selection
Fig. 28: Sticker
11) Gearbox drive cover
12) Sweeping cylinder gearbox
13) Sweeping cylinders
14) Mudguard
15) Turning lever
16) Support wheel
17) Spacers
18) Guide rails
19) Dozer blade
20) Reaction arm
3b) Revolution setting lever B&S and VARI XP-200
3a) Revolution setting lever HONDA engine
See the picture at the Chapter 4 .
Fig. 4: Accelerator lever positions
Fig. 6: Faster drive – hare position
Fig. 8: Sticker – speed selection
6)
7)
8)
9)
10)
Fig. 12: Tipping the waste out of the collector
Fig. 14: Dozer blade mounting
Fig. 16: Mounting the dust cover
Fig. 18: Drive pulley
Fig. 20: Frame bowden cables
Fig. 22: Replacement of the cylinder sweeping brushes
4) Guiding screws for the sweeping cylinders drive belt on the gearbox driven
pulley
5) Guiding pins for the sweeping cylinders drive belt on the engine driving pulley
6) Guiding screw on the pulley
4)
5)
6)
Fig. 27: Combined sticker
Fig. 29: Sticker
CB-80 CB-80B CB-80Z CB-80ZI
21) Supporting wheels
22) Tube frame
23) Collector
24) Sealing strip
25) Guiding wheel
26) Lifting rod
27) Screen
28) Frame
29) Bowden cable ties
4) Sweeping cylinder turning control lever
MIN:
2
"Turtle" position
Engine runs in neutral rpms.
Short-term work rest

CHOKE:
4
Engine runs on choke (only HONDA engines).
Engine cold start

Collector frame foot
Split pin
Spacer
Sweeping cylinder turning control lever
Plastic rest
Drive axle
Bearing bodies nut
Slot in the side cover of the frame
35