KitchenAid 5KSM7990X Bedienungsanleitung Seite 11

3.
(OPTIONAL) To adjust Beater to Bowl Clearance: Lower the Bowl to the down position.
Locate the screw revealed when the Bowl is lowered.
NOTE: Do not adjust the screw located on the Spring Latch.
Turn the screw slightly counterclockwise (left) to raise the beater, or clockwise (right) to
lower it. Adjust the beater so that it just clears the surface of the Bowl. Check again the
clearance of the Beater to the Bowl.
IMPORTANT: When properly adjusted, the Stainless Steel Flat Beater will not strike on the
bottom or sides of the Bowl. If the Flat Beater or the Wire Whip is so close that it strikes the
bottom of the Bowl, coating may wear off the beater or wires on the whip may wear.
4.
To attach the Bowl Guard***: Make sure that the guard is returned to the down position
before beginning to use the Stand Mixer. The Stand Mixer will not run if the Bowl Guard is
not in the proper position.
Stop Switch: If you need to stop the Stand Mixer immediately during use, press the Stop
Switch. To resume operation, reset the Speed Control Lever to off (0), and pull out the
Stop Switch. Then, your Stand Mixer is ready to be used normally again.
***Available with select models only and available as an accessory purchase.
A
A. Raise Bowl
B. Lower Bowl
A
A. Stop Switch
B
11