Abus RWM450 Bedienungsanleitung Und Wartungsanleitung Seite 53

The mounting site must be
• firm
• dry
• free of dust, grease or loose paint,
etc.
Application:
a) Remove the information sticker
and the protective film from the
self-adhesive surface (Fig. 3) of the
magnetic holder.
b) Press the adhesive surface of the
magnetic holder for approx. 10
seconds firmly onto the mounting
surface.
c) Fit the alarm unit onto the
magnetic holder.
d) The adhesive bond will reach its
final strength after approx. 72 hours.
ved from the magnetic holder by
pulling it gently vertically away
1.2 Adhesive mounting using optional
The additional use of this optional
adhesive produces an
• and long-lasting joint between the
• The alarm unit cannot now be
Only use this method of xing when
you are absolutely certain that the
unit must remain permanently xed
and that it should not be removed.
Fig. 3
– 53 –
Fire Protection Association) 14/01
addition to 1.1
with the installation site.
removed by pulling it from the
cantly greater security against
GB