Aquaglide FREEFALL SUPREME Bedienungsanleitung Seite 10

OPERATION
Freefall Supreme Trickler Kit is an optional accessory for wetting down the slide surface of a
floating slide during use. Users sit at the top of Freefall Supreme and slide feet first into the water
body. This kit is designed for Freefall Supreme TR only.
PVC surfaces are slipperier when wet, which can lead to loss of balance when walking or
climbing.
Supervise During Use: Trickler Kit is designed to reduce the possibility of tampering,
but should never used without supervision. Intentional or accidental tampering may cause
failure, damage or misalignment of the system. Never allow pulling, hanging, or rough play
around the system.
Monitor for changes: Inspect the system regularly and monitor for any changes that
might allow injury, or indicate the system needs attention. Discontinue use immediately until
appropriate corrective action is taken.
Adjust and Realign: Slight misalignment of the drip emitter may cause uneven water flow.
Typically this can be corrected manually without tools by pulling or twisting emitter pocket
holes into alignment with drip emitter. If not, disassemble drip emitter and repeat 'Assembly'
Step 2 (a - c) with similarly sized zip ties.
Fluctuations in water pressure, water usage, and even environmental conditions like wind
changes may require slight adjustments in the trickler water volume. The goal is to direct a
steady stream of water just at the top of the slide surface. Too little water flow will result in
wetting the top surface, not the slide face. Too much water may only wet the lower half of
the slide face. This adjustment can be made using the lever on the hose shutoff.
Replace any parts showing signs of wear. Trickler hoses can be replaced if necessary using
1/2" (12mm) ID reinforced polyurethane hose.
10 www.aquaglide.com