Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Installation
All dimensions in these chapters are given in millimeters.
The minimum distances required for proper ventilation can be found in chapter
3.2.2 V
ENTILATION
3.1 Unpacking and positioning
WARNING While unpacking, the packaging materials (polythene
bags, polystyrene pieces, etc.) should be kept away from children and
pets. CHOKING HAZARD RISK OF INJURY
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Remove all packaging materials.
3. The accessories of your appliance can be protected from damage due to
transportation (adhesive tapes etc.). Remove such tapes very carefully. Remove
remains of such tapes with a damp cloth using lukewarm water and a mild
detergent (see also chapter
components of the back of the appliance!
4. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
5. If installation near a heat source is unavoidable, use a suitable insulation plate or
keep the following minimum distances to the heat source:
To electric cookers
To radiators or ovens
To another refrigerators
6. Check that the appliance and the power cord are not damaged.
7. Install the appliance in a dry and well-ventilated place.
8. Protect the appliance from direct sunlight.
9. The door(s) must open completely and without hindrance.
10. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
11. Connect the appliance to the mains properly.
12. The rating plate is inside the appliance or at the back.
.
CLEANING AND MAINTENANCE
53
at least 30 mm
at least 300 mm
at least 20 mm
). Never remove any
Werbung
