Commissioning Using Lenze Settings - Lenze 8200 motec Montageanleitung

Commissioning using Lenze settings


Note!
The basic device is only functioning if a HIGH level is applied to X3/28
(controller release via terminal).
Please observe that the controller can be inhibited through various
ƒ
sources. All sources act like a series connection of switches.
If the drive does not start in spite of the controller release via X3/28, check
ƒ
if the controller inhibit is set via another source. Another source could be
the  key of the keypad.
EDK82ZMFBC-001 DE/EN/FR 7.0
Commissioning using Lenze settings

Commissioning 7
55