Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Measuring Process
Once switched on, the measuring tool is in the length measure-
ment function.
The rear edge (3) of the measuring tool is always the reference
level for the measurement.
Apply the rear edge (3) of the measuring tool to the point
at which you want to start the measurement (e.g. wall).
Press the
button to complete and save the measure-
ment.
Once the measurement process is complete, the laser beam
will switch off. For a further measurement, repeat this pro-
cess.
For more information, you can access the online op-
erating instructions at www.bosch-pt.com/manuals
A continuous measurement is performed after the
measuring tool has been switched on. The current
measured value (c) is shown on the top line of the display.
During continuous measurement, the measuring tool can be
moved relative to the target, during which the current meas-
ured value will be updated approx. every half a second.
The reception lens (9) and the laser beam output (8)
must not be covered during the measuring process.
Measuring functions
Available measuring functions:
–
Length measurement
–
Area calculation: Areas can be calculated using two dis-
tance values in some product variants.
Bosch Power Tools
English | 25
1 609 92A 7WZ | (16.06.2023)
Werbung
