Roidmi EVE CC Benutzerhandbuch Seite 9

Installation of Mopping Module
First, install the mop. Insert the wrung damp mop into the mop holder and paste it on
the Velcro. Then fill the two-in-one water tank with water. Open the rubber cap of the
two-in-one water tank inlet, pour clean water into the tank, then fasten the rubber cap.
Next, install the mopping module. Install the mopping module into the bottom of the
two-in-one water tank according to the direction shown in the diagram. Finally, install
the two-in-one water tank. Install the two-in-one water tank into the main unit according
to the direction shown in the diagram, until you hear a "click" sound.
Caution
Do not pour hot water into the two-in-one water tank to avoid deformation of the
•
water tank; do not flush or soak the two-in-one water tank.
Do not use detergents, disinfectants, solid detergents, and other cleaning
•
products to prevent corrosion and blocking of the two-in-one water tank.
Due to production testing reasons, there may be a small amount of water residue
•
in the two-in-one water tank, which is a normal phenomenon.
When mopping the floor, set up virtual walls or a no-go area in carpeted areas;
•
do not use the mopping function on the carpet.
When the device is charging or not in use, remove the mopping module, pour out
•
the excess water in the water tank, and clean the mop to avoid mildew or odours.
It is recommended to clean the mop after each use to ensure the water output
•
speed and cleaning effect. If necessary, the mop can be replaced with a new one.
When the main unit is charging on a wooden floor, timely remove the mopping
•
module to prevent the mop from leaking and damaging the floor.
9