Roidmi EVE CC Benutzerhandbuch Seite 19

Frequently Asked Questions
Fail to power on.
The battery power is low. Please put the main unit back in the dust collection
•
station for charging before use.
Fail to charge.
The dust collection station is not powered on. Please make sure the power supply
•
is connected. The charging electrode plates are not in good contact. Please clean
the charging pins of the dust collection station and the charging electrode plates
of the main unit. The ambient temperature is too low (below 0°C) or too high
(above 45°C).
Fail to return to the dust collection station to recharge.
There are too many obstacles near the dust collection station. Please place the
•
dust collection station in an open area. The distance between the main unit and
the dust collection station is too far. Please place the main unit near the dust
collection station and try again.
Abnormal operation.
Please turn off the robot and restart it.
•
Abnormal noise during cleaning.
The rolling brush, side brush, wheels, or omni wheel may be entangled with
•
foreign objects. Please turn off the robot and clear it.
Reduced cleaning capability or dust collection capability.
The two-in-one water tank dust bin is full. Please clear the dust bin. The filter is
•
blocked, and please clean it. The rolling brush is entangled with foreign objects,
and please clean it.
The mopping module does not release water, or the amount of water released is
small.
Please check if there is water in the water tank; please use the mobile app to
•
adjust the water volume to the maximum level; please install the mop and mop
holder properly according to the manual.
19