Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX Mode
The LED display allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PIX-3 Flower Effect will respond to the controller.
Controlling:
After having addressed the LED PIX-3 Flower Effect, you may now start operating it via your lighting
controller.
Note: It' s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.
Addressing
Press the MODE button until the display shows " 512" then press the ENTER button to confirm.
Set the desired address via the UP or DOWN buttons (001 - 512).
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
DMX Channel Selection: Choosing a DMX Channel Mode
After having set the desired address(es) and pressed ENTER, you can now choose a DMX Channel Mode.
(2 CH or 3 CH).
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm and to exit the DMX Mode.
Please see the following DMX protocol graphics for the respective channel values.
DMX Protocol
2-Channel Mode:
Channel 1 - Auto Programs
Value:
000 – 015
016 – 089
090 – 164
165 – 240
241 – 255
Channel 2 – Strobe
Value:
000 – 000
001 - 255
Function:
Blackout
Auto program slow
Auto program middle
Auto program fast
Auto program sound control
Function:
No function
Flash, with increasing speed
23/26
00065460.DOC, Version 1.1
Werbung
