Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
After you connected the EUROLITE LED PIX-3 Flower Effect to the mains, the device starts running.
The LED display lights up and you can now choose the desired settings via the buttons MODE, ENTER, UP
and DOWN.
- STANDALONE-MODE
- Auto Mode
- Sound Mode
- Master/Slave Mode
- DMX MODE
Stand Alone-Mode
Auto Mode
In Auto Mode the internal program is called up automatically in a continuous loop.
Press the MODE button until the LED display shows " AUTO" .
Please press the ENTER button to confirm.
To set the desired program speed, press the MODE button until the LED display shows " s---" . The desired
speed (s001 - s100, increasing) can be selected via the UP or DOWN buttons.
Please press the ENTER button to confirm.
Sound Mode
Press the MODE button until the LED display shows " snd" .
Please press the ENTER button to confirm.
Master/Slave Mode
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the Master device to Auto or Sound Mode and set each Slave device to the same DMX address " d001" .
22/26
00065460.DOC, Version 1.1
Werbung
