Installing The Safety Assembly; Appliance Installation; Water Connection; Power Supply - STIEBEL ELTRON SH 10 SLi Bedienung Und Installation

INSTALLATION
Installation
9.1

Installing the safety assembly

f Fit the prospective safety assembly in the cold water supply f
line of the appliance.
f Observed the information on the safety assembly (see chap- f
ter "Installation / Safety / Information on safety assembly").
f Observe the information in the installation instructions of the f
safety assembly.
9.2

Appliance installation

f Mark out the holes for drilling with the installation template f
supplied.
f Drill the holes and insert suitable rawl plugs. f
f Secure the wall mounting bracket using suitable screws. f
f Hang the appliance on the wall mounting bracket. f
Note
Surplus cable can be stored in the cable compartment.
9.3

Water connection

Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
Material losses
!
Counterhold with a suitable spanner when tightening the
fittings.
Material losses
!
The appliance may lose its function.
f Never interchange the water connections. f
f Set the flow rate (see safety assembly instructions). f
Observe the maximum permissible flow rate with a
fully opened tap (see chapter "Installation / Specifi-
cation / Data table").
www.stiebel-eltron.com
Match up the colour coding on the tap water connections and the
appliance:
- R.h. side blue = "Cold water inlet"
- L.h. side red = "DHW outlet"
f Secure the water connections from the tap to the appliance. f
9.4

Power supply

WARNING ELECTROCUTION
Carry out all electrical connection and installation work
in accordance with relevant regulations.
WARNING ELECTROCUTION
When permanently connected to the power supply using
an appliance wall socket, the appliance must be able to
be separated from the mains power supply by an isola-
tor that disconnects all poles with at least 3 mm contact
separation.
WARNING ELECTROCUTION
Ensure that the appliance is earthed.
Material losses
!
The voltage specified on the type plate must match the
mains voltage.
f Observe the type plate. f
The following electrical connections are permissible:
Connection to a freely accessible
standard socket
Permanent connection to an ap-
pliance junction box with earth
conductor
Fixed power cable with the perma-
nent connection set
The permanent connection set maintains the IP 24 D protection
rating when converting the appliance.
SH 10 SLi SH 15 SLi
X
X
-
SH 10 SLi | SH 15 SLi | 15
X
X
X