Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. USING THE BATTERY CHARGER
4.1 BATTERY STATUS INDICATORS
The 4 LED indicators on the charger light up for 30 seconds
depending on the level of charging.
1
LED red
= 0%
st
1
LED white = 1% – 24%
st
2
LED white = 25% – 49%
nd
3
LED white = 50% – 74%
rd
4
LED white = 75% – 100%
th
Note:
You can check the battery charge level by inserting the
battery in the charger when the charger is not connected to
an electric socket.
4.2 CHARGING THE BATTERY FOR THE FIRST TIME
For safety and transportation reasons, the battery is not sup-
plied fully charged. Please charge the battery fully using the
RBC battery charger supplied before using the device for the
first time (point 2.1).
1. Connect the plug of the USB charging cable to the USB
port on the charger.
2. Connect the other end of the USB charging cable to a
suitable USB block adapter.
3. Insert the battery in the charger.
4.3 CHARGING TIME
90 % battery level after 3.5 hours
100 % battery level after 5 hours
Note:
The power supply used (not provided) should have an output
of at least 2.1 A to allow two batteries to be charged simul-
taneously. In the case of lower output, charge each battery
individually.
38
AX VISIO / EN
AX VISIO / DE
4.4 BATTERY CHARGER ERROR INDICATORS
1
LED flashing red for the second inserted battery ª Output
st
current of the USB charging power supply is too low to char-
ge two batteries simultaneously.
1
and 2
LEDs flashing red ª Battery temperature too low
st
nd
(< 0°C/32°F).
3
and 4
LEDs flashing red ª Battery temperature too high
rd
th
(> 45°C/113°F)
All 4 LEDs flashing red ª Battery is faulty. Stop using the
battery immediately.
All 8 LEDs are illuminated red ª Charger is faulty. Stop using
the charger immediately.
1
LED flashing red ª Battery is discharged.
st
4.5 GENERAL INFORMATION FOR USE OF THE
RBC BATTERY CHARGER IN THE UNITED STATES
This product is validated according to UL62368-1. This pro-
duct should be fitted with a ITE-listed "Class 2" or LPS block
adapter with a USB output of 5 V DC min. 2100 mA.
This product is designed only for charging the SWAROVSKI
OPTIK RB rechargeable battery, RB AFL+ rechargeable
battery, and RB tM 35 rechargeable battery.
5. GENERAL INFORMATION
5.1 SERIAL NUMBER
You can find the serial number of
your product on the bottom of the
device between the mode selection
wheel and the focusing wheel. To
see the serial number clearly, open
the device out fully.
AX VISIO / EN
AX VISIO / DE
39
Werbung
