Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

USE OF THE SAFETY BELTS
Fig 19
After laying the child in the stroller, fasten the belts as follow : as the first slide the buckle of the right shoulder
belt into the central buckle and secure it with the right waist belt, repeat the same action even for the left part
of the retraining system. Adjust the length of the belts, making sure they adhere to your child's shoulders and
body.
To unfasten the restrain system press the central button.
WARNING: Always use the restraint systems. For the safety of your child use all five fixing points of the
safety harness belts.
WARNING: To ensure the safety of your child, use the safety belts at all times.
For further safety, the stroller is equipped with ''D''-shaped rings to allow hooking an additional safety belt,
compliant with BS 6684 standard. The rings are located inside the stroller's seat on the right and left side
Note: When use the winter foot-muff, pass the retaining system by the holes in the foot-muff as the first. For
their settings follow the instructions given above in the article "USE OF THE SAFETY BELTS".
REMOVING THE SAFETY BELTS
13. The safety belts can be removed (to be washed or used in pram configuration).
If you want to remove the safety belt, it is necessary to stretch the clip-foot strip and pull it through the hole in
the seat outwards, then pull the buckle shoulder straps and pull them through the holes in the backrest
outwards. The waist belts are firmly attached to the stroller, so for the pram configuration cover the waist belt
by the extra padding.
After removing the seat belt, make sure that the new installations would be passed through anchor points
correctly. For new installation, please follow the steps below carefully:
Pull the clip through the hole for between-foot belt. Make sure that the buckle pass through the hole and the
belt with the central buckle was turned towards you.
After that, pull the buckle of the shoulder belt through the hole in the backrest and secure it, the same repeat
for the second shoulder belt.
WARNING: At the end of the assembly, the belts must be adjusted once again according to the size of your
child.

PARKING BRAKE

15-0658_Navod_Gmini_Grand.indd 26
15-0229_Navod_Gmini_Grand.indd 26
12. The stroller is equipped with a retaining system with five anchoring
points, consisting of two shoulder straps, two waist belt and a crotch
strap with buckle, already assembled.
WARNING: To adopt the retaining system to the body of the child, it is
possible to adjust them!
14. The stroller is equipped with pedal parking brake located on the
rear axle. To engage the parking brake, press the pedal downward with
one foot. To disengage the parking brake, push the pedal upward, see Fig 20.
WARNING: Always use the brake when not moving. Never leave the stroller on a
sloping surface with your child inside it, even if the parking brake is engaged.
WARNING: After engaging the parking brake, make sure the brakes are
properly enabled on both rear wheels.
Fig 20
3.7.2015 10:26:50
12.3.2015 11:00:24

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

1888:2012

Inhaltsverzeichnis