Gmini Grand Anleitung Seite 22

Fig 5
WARNING: Both wheels must always be locked or released to swivel at the same time.
WARNING: Before using the stroller, make sure that the wheels are well secured to the structure.
ASSEMBLY OF THE SEAT: STROLLER CONFIGURATION
15-0658_Navod_Gmini_Grand.indd 22
15-0229_Navod_Gmini_Grand.indd 22
2. Place rear axle into stroller frame. You should hear snap. Ensure that the
brake is facing the rear.
Fig 2
3. Place the rear wheels into axle pins. When you adjusted properly you should hear
"click". Make this action for the second front wheel too.
IMPORTANT: Inflate tires of rear wheels max. 35 PSI (240 KPa) / (2.4 BAR), be
careful not to exceed the specified value.
Fig 3
4. Place the front swivel wheels into front housing. When you adjusted properly
you should hear "click". Make this action for the second front wheel too.
WARNING: Before using the stroller, make sure that the wheels are well
secured to the structure.
Fig 4
5. The stroller is equipped with front swivel/fixed wheels.
It is suggested to use the fixed wheels on particularly uneven grounds. The wheels
in swivel mode instead, can be used to improve the stroller's handling on regular
road surfaces.
To lock the front swivel wheels, press down the locking button on the front yoke. To
release the locking device of the front fixed wheels, press again the locking button
with your foot. Regardless of the position in which the wheel is located, they will
lock in straight position.
6. Put the seat into the corresponding holes on the construction of a stroller, as
shown in Figure 6, you should hear a click fuses.
WARNING: Make sure the seat is installed properly by pulling it upward.
Fig 6
3.7.2015 10:26:48
12.3.2015 11:00:23