Restoring The Original Configuration - Somfy Altus 40 Rts Anleitung

EN
2.4.3. Replacing a lost or broken Somfy control point
Attention
Only switch off the power to the application to be
reset.
This reset deletes all the local control points, however
the sensors, end limit settings and favourite position are
retained.
1) Position the motorised product at the mid-height
position.
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on: the motorised product
moves for a few seconds. (If the application is in the
upper or lower limit position, it will make a brief up and
down movement).
6) Press the PROG button on the new control point until the
motorised product moves up and down: the new control
point is programmed and all the other control points are
deleted.
2.4.4. Restoring the original configuration
Attention
Only switch off the power to the application to be
reset.
This reset deletes all control points, all the sensors and
all the end limit settings, and resets the motor's favourite
position (my).
1) Position the motorised product at the mid-height
position.
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on: the motorised product
moves for a few seconds. (If the application is at the
upper or lower end limit, it will make a brief up and down
movement).
6) Press the PROG button on the Somfy local control point
for ≈ 7 seconds, until the motorised product moves
up and down twice:
→The motorisation is reset to the original configuration.
Repeat the commissioning procedure
(see Commissioning) section.
8
©
Copyright 2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1) 2)
3) 4)
10 sec.
5)
6)
PROG.
B B
1) 2)
3) 4)
10 sec.
5)
6)
PROG.
A A
X 2
ALTUS 40 RTS
2 sec.
2 sec.
A
2 sec.
2 sec.
A B
C C C
MY