Commissioning; Pre-Programming The Rts Control Point; Checking The Direction Of Rotation; Setting The End Limits - Somfy Altus 40 Rts Anleitung

ALTUS 40 RTS

2.3. COMMISSIONING

2.3.1. Pre-programming the RTS control point

1) Switch on the power supply.
2) Press the UP and DOWN buttons simultaneously on the
RTS control point: The motorised product moves up and
down briefly and the control point is pre-programmed in
the motor.

2.3.2. Checking the direction of rotation

1) Press the UP button on the RTS control point : P
• If the motorised product rises (a), the direction of
rotation is correct: Move onto the section entitled

"Setting the end limits".

• If the motorised product lowers (b), the direction of
rotation is incorrect: Move onto the next step.
2) Press the my button on the RTS control point until the
motorised product moves up and down: The direction of
rotation has been modified.
3) Press the UP button on the RTS control point to check
the direction of rotation.
2.3.3. Setting the end limits
The end limits can be set in any order.
1) Raise the motorised product to the desired position by
pressing the UP button.
2) Press the my and DOWN buttons simultaneously until
the motorised product moves. The upper end limit is
memorised.
3) Press the my button when the motorised product
reaches the desired lowered position. If necessary,
adjust the position of the motorised product using the
UP and DOWN buttons.
4) Press the my and UP buttons simultaneously until
the motorised product moves. The lower end limit is
memorised. The motorised product rises and stops in
the raised position.
5) To confirm the end limits, press the my button until the
motorised product moves up and down,
The end limits are programmed.
©
Copyright 2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1)
1)
a
=
b
=
2) 3)
1) 2)
3) 4)
5)
EN
5