Herunterladen Inhalt Inhalt Diese Seite drucken

Wiring - Somfy Altus 40 Rts Anleitung

Vorschau ausblenden Andere Handbücher für ALTUS 40 RTS:
Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
EN
2.1.3. Drive/tube assembly
1) Slide the drive into the winding tube.
For winding tubes with a smooth interior, position the
cut notch on the crown.
2) The drive wheel must be locked in place to prevent any
movement in the winding tube: This can be achieved by
fastening the winding tube to the drive wheel using 4
self-tapping screws, Ø 5 mm, or 4 steel pop rivets, Ø 4.8
mm, placed between 5 mm and 15 mm from the outer
edge of the drive wheel, regardless of the winding tube.
Attention
The screws or pop rivets must only be fastened onto the drive wheel and not on the drive.
2.1.4. Installing the drive/tube assembly
1) Install and fi x the drive/tube assembly onto the end
bracket f and onto the drive bracket g.
Attention
Ensure that the drive/tube assembly is secured onto
the end bracket. This operation prevents the drive/tube
assembly from coming out of the end bracket mounting.
2) Depending on the type of bracket, fi t the stop ring h in
place.

2.2. WIRING

Precaution
• Cables which pass through a metal wall must be protected and isolated using a sheath or
sleeve.
• Attach cables to prevent any contact with moving parts.
• If the drive is used outdoors, and if the power supply cable is a type H05 VVF cable, the cable
should be installed in a UV-resistant duct, e.g. under a gland.
• The drive cable cannot be removed. If it is damaged, return the drive to the After-Sales
department.
• Always make a loop in the power supply cable to prevent water entering the drive.
Attention
Leave the drive power supply cable accessible: it must
be possible to replace it easily.
• Switch off the power supply.
• In the case of using an extension cable with fast con-
nector plug the extension cable with female i fast con-
nector to the motor extension cable with male j fast
connector.
• Connect the drive according to the information in the
table below:
Neutral (N)
230 V 
 50 Hz
Attention
Do not use as a switch.
• Make sure that the clip k is correctly positioned to
ensure closure.
4
Live (L)
Blue
Brown
k
Copyright
1)
2)
g
2)
N
N
nc
L1
not connected
©
2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
ALTUS 40 RTS
L
h
L
L
nc
N
nc
f
Inhaltsverzeichnis
loading

Inhaltsverzeichnis