Liability; Installation; Assembly; Preparing The Tube - Somfy Altus 40 Rts Anleitung

ALTUS 40 RTS

1.2. LIABILITY

Before installing and using the drive, please read these instructions carefully. In addition to the in-
structions provided in this guide, please also comply with the instructions set out in the enclosed
Safety instructions document.
The drive must be installed by a home motorisation and automation professional, in accordance with
Somfy's instructions and the applicable regulations in the country of installation.
Any operation of the drive outside the sphere of application described above is prohibited. Such op-
eration shall exclude Somfy from all liability and invalidate the Somfy warranty, as will any failure to
comply with the instructions given herein and in the enclosed Safety instructions document.
A er installing the drive, the installer must inform his customers of the operating and maintenance
conditions for the drive and must pass the operating and maintenance instructions on to them, as
well as the enclosed Safety instructions document. Any A er-Sales Service operation on the drive
requires intervention by a home motorisation and automation professional.
Should any doubt arise during installation of the drive or for additional information, consult a Somfy
contact or visit www.somfy.com.

2. INSTALLATION

Precaution
• These instructions are mandatory for the home motorisation and automation professional
installing the drive.
• Comply with current standards and legislation in the country of installation.
Attention
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.

2.1. ASSEMBLY

2.1.1. Preparing the drive
Check that the inner diameter of the motorized product's tube is
greater than 37 mm.
1) Fit the accessories required to integrate the drive into the
winding tube:
• Either fit the drive wheel a on the drive.
• Or fit the crown b and the drive wheel c on the drive.
2) Measure the length (L) between the inner edge of the
drive head and the rim of the drive wheel.

2.1.2. Preparing the tube

1) Cut the winding tube to the required length, depending on
the motorised product.
2) Deburr the winding tube and remove the swarf.
3) For winding tubes which are smooth inside, cut a notch
with the following measurements: d = 7 mm, e = 10 mm.
©
Copyright 2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
y
1)
Ø = 37 mm
a
2)
L = ...
L
1) 2)
3)
d
EN
Ø > 37 mm
b c
e
3