Tips And Advice On Installation - Somfy Altus 40 Rts Anleitung

EN
2.3.4. Recording the RTS control point
The motorisation is in programming mode:
Briefly press the PROG button on the RTS control point to
be programmed: The motorised product moves up and down
→this RTS control point is programmed in the motorisation.
OR
1) Switch off the power supply.
2) Switch on the power supply. the motorised product
moves up and down.
3) Simultaneously press the UP and DOWN buttons on the
RTS control point. The motorised product moves up and
down.
4) Press briefly the programming button on the back of the
control point. The motorised product moves up and down.
The control point is programmed in the motorisation.

2.4. TIPS AND ADVICE ON INSTALLATION

2.4.1. Questions about the drive?
Observations
The wiring is incorrect.
The motorisation is in thermal
protection.
The control point battery is weak.
The motorised
product does
The control point is not compatible.
not operate.
The control point used has not been
programmed into the motor.
The power supply is not compatible.
End-limits are not properly adjusted.
The motorised
Crown is not properly fitted to the
product stops
tube.
too soon.
The motorised product is within the
recommended weight limit.
6
Possible causes
©
Copyright 2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
PROG. OG O O
2)
3) 4)
Solutions
Check the wiring and modify it if
necessary.
Wait until the motor cools down.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or
program this control point.
Check the power supply specifications
and replace it if necessary.
Adjust the end-limits.
Fit the crown properly to the tube.
Consult a Somfy contact or visit
www.somfy.com.
ALTUS 40 RTS
PROG. O O OG