LSL R1ST Montageanleitung Seite 6

Check clearance to the tank, therefore you have to mount all controls provisorily on the clip-on.
Tighten the bolts of the Tour-Match clamps M6x25 with 10Nm. Now drill the bores for the controls
and fix them finally.
Instruction for rerouting cables hoses and wiring harnesses:
Throttle cable
Brake line
Clutch cable
Wiring harnesses
Make sure that no cable, hose or harness is bended and stays tension-free over the whole steering
angle.
Connect the battery to the ground of your vehicle.
The Tour-Match kit is now completely mounted. Always check local laws and your
manufacturer's warranty conditions for using aftermarket parts on your bike!
Ride safe and have fun!
——————————————
Rev. 00 09/09/2014
: remaining as original
: check easy move of throttle cable at full angle
: remaining as original
: remaining as original
:
remaining as original
Zubehör von
,
— Das Original ——
Seite 6 von 6