LSL R1ST Montageanleitung Seite 5

fitting:

The battery ground should be disconnected before working on electric wiring and switches!
Remove handlebar controls, clutch and brake cylinder assy and original handlebar.

Before you start to remove the top yoke relieve front wheel.
Remove the top yoke and put the Tour-Match clamps on your slider tubes, then reinstall your top
yoke again.
Take care to tighten the central nut first with about 15Nm, then tighten the clamping bolts of the
top yoke with the torque which is given by the manufacturer.
Now tighten the central nut with manufacturer´s torque.


——————————————
Rev. 00 09/09/2014
!
Zubehör von
Align Tour-Match clamps with bolts
M6x25mm about 6mm below the top
yoke to avoid a collision to the
intruments bracket!
Align Tour-Match clamps
provisorily and mount them handtight.
Now install the handle tubes with
M6x22 at Tour-Match clamps and
tighten these bolts with 10Nm.
Modify the steering stop!
To gain more clearance between clip
ons and fairing you have to modify the
steering stop.
Use suitable glue to fix the aluminium
shims (t=2mm) on the steering stop.
— Das Original ——
Seite 5 von 6