RECA dimos UNI-RT 12 Bedienungsanleitung Seite 4

Page 3 of 32 of European Technical Assessment no. 23/0482, issued on 2023-09-05
II SPECIFIC PART OF THE
EUROPEAN TECHNICAL
ASSESSMENT
1 Technical description of product
Technical description of the product
RECA dimos anchor UNI-RT 12 and RECA
dimos anchor UNI-RT 16 are post-installed
anchor systems placed into predrilled holes in
concrete, in masonry and autoclaved aerated
concrete and anchored by bonding.
RECA dimos anchor UNI-RT 12 and RECA dimos
anchor UNI-RT 16 distance mounting system
consist of a M12 or M16 threaded rod made from
carbon steel or stainless steel and a thermal
separation module made from polyamide. The
fixing system is placed into a pre-drilled hole
perpendicular to the surface (maximum deviation
5°) in masonry or concrete, and anchored by
bonding the threaded rod element to the wall of the
drilled hole.
The product description is given in Annex A.
2 Specification of the intended use
in accordance with the applicable
European Assessment Document
(hereinafter EAD)
The intended use is fixings through an ETICS into
the loadbearing wall of heavy-duty fixtures such
as awnings, French balconies, canopies, satellite
dishes, etc.
The system is used for distance mountings in the
following insulated base materials:
• Normal weight cracked or non-cracked
concrete (base material group a)
• Solid masonry bricks
(base material group b)
• Perforated or hollow bricks
(base material group c)
• autoclaved aerated concrete
(base material group d)
Reference to base material group in EAD
330499-02-0601 and EAD 330076-00-0604.
Anchorages subject to: Static or quasi-static
loads.
Temperature range:
•
T1: -40°C to +40°C (max. short-term +40°C
and max. long-term temperature +24°C)
•
T2: -40°C to +80°C (max. short-term +80°C
and max. long-term temperature +50°C)
The minimum and the maximum installation
temperature are specified by the manufacturer
within the above range.
Use categories in respect of use:
Category d/d: Use in dry masonry and concrete
Category w/w: Use in wet masonry only.
This ETA applies only where concrete or masonry
members in which the distance mounting
systems are embedded are subject to static or
quasi static actions in tension, pressure, shear or
combined tension and shear or pressure and
shear or bending.
In case of a product use in ETICS or façade
insulation systems, it must be ensured that no
ETICS or facade insulations systems influence
the loadbearing capacity in the base material.
The performances given in Section 3 are only
valid if the anchor is used in compliance with the
specifications and conditions given in Annex B.
The provisions made in this European Technical
Assessment are based on an assumed intended
working life of the anchor of 50 years.
The indications given on the working life cannot
be interpreted as a guarantee given by the
producer or Assessment Body, but are to be
regarded only as a means for choosing the right
products in relation to the expected economically
reasonable working life of the works.