RECA dimos UNI-RT 12 Bedienungsanleitung Seite 19

Page 18 of 32 of European Technical Assessment no. 23/0482, issued on 2023-09-05
dimos anchor UNI-RT 12, dimos anchor UNI-RT 16: Installation instruction (in hollow brick)
Installation in hollow base material:
The mounting instruction uses as an example a sleeve 20-130 (diameter 20 mm with length 130 mm).
Any sleeve according to the ETA of the RECA injection mortar from Annex B1 can be used.
RECA dimos anchor UNI-RT 12, RECA dimos anchor UNI-RT 16
Intended use
Installation instruction in hollow masonry
1. Drill a hole:
Observe the drilling method of the approval/assessment of
the injection mortar. Perforated bricks: Rotary drilling -
without impact.
dimos anchor UNI-RT 12 and dimos anchor UNI-RT 16:
Drill hole diameter d = 20 mm
0
Drill hole depth h1 ≥ 140 mm + e
(e = insulation thickness incl. plaster & t
2. Clean the drill hole:
The drill hole must be cleaned properly; see approval /
assessment of the injection system:
2x blow - 2x brush - 2x blow.
3. Cut the dimos anchor UNI-RT to length
The pre-assembled threaded rod M12 / 16 is already
completely screwed into the thermal separation module.
Correct length L from the tip of the threaded rod to the
dK
lower edge of the cover plate of the thermal separation
module:
Anchorage depth in plastic sleeve (125 mm) +
insulation thickness e (incl. plaster)
After determining the correct length, cut the threaded rod
M12 / M16 to length with a metal saw.
4. Enlarge the opening in the plaster for the collar of
the plastic sleeve to 26mm.
To do this: Screw the thermal separation module only
approx. 2 thread turns through the plaster using a
cordless screwdriver and the bit included in the set. Then
screw it out again.
Note: If the plaster is very thick and hard, use a Ø 26 mm
drill bit or „ream" the hole in the plaster to
approx. 26 mm with the drill.
5. Push the plastic sleeve into the drill hole with the
help of a folding ruler or similar
Then remove the folding ruler or similar from the drill hole.
Note: This is an ideal way to ensure that the sleeve SH
20x130 is correctly inserted in the drill hole.
)
tol
Annex B8