Insulation Thickness Incl. Insulation Plaster; D [Mm]; L [Mm]; Uni-Rt 12 - Reca Dimos Uni-Rt 12 Bedienungsanleitung

Page 14 of 32 of European Technical Assessment no. 23/0482, issued on 2023-09-05
Table B 4.1: Installation parameters in base material (see drawing in Annex A2)
Anchor type

Insulation thickness incl. insulation plaster

Min. thickness of member
Effective anchorage depth
Drill hole diameter
Depth of drill hole in the base material
Diameter of clearance hole in the fixture
for the M12 threaded stud
Diameter of clearance hole in the fixture
for the M12/M10 threaded stud
Length of threaded stud
Thickness of fixture
Installation torque to fix the fixture *
For hollow base material perforated sleeves must be used for the injection mortar, in accordance with ETA of injection
mortar.
* T = 19 Nm resp. 25 Nm are valid for the thermal separation module. Max. T
inst
must also be observed.
a)
as delivered with threaded stud M12 or with reduction threaded stud M12/M10
b)
with any longer threaded rod, washer and nut which complies to the specifications given in table A 5.1 position
3 and 3a. The introduction of bending moment is not allowed. Constructive measures must be applied to
exclude any bending moment
RECA dimos anchor UNI-RT 12, RECA dimos anchor UNI-RT 16
Intended use
Installation parameters

UNI-RT 12

h [mm]
60 - 220
D
h [mm]
min

h [mm]
ef
in accordance with injection mortar ETA
d [mm]
0

[mm]
h
1

[mm]
d
f

[mm]
d
f
Lp 
[mm]
0 – 24
t [mm]
fix
max. 200
≤
[Nm]
T
inst
UNI-RT 16
60 - 300
13 13
11 11
50 50
0 – 24
a)
b)
max. 200
19 25
given in ETAs of injection mortar
inst
a)
b)
Annex B4