RECA dimos UNI-RT 12 Bedienungsanleitung Seite 22

Page 21 of 32 of European Technical Assessment no. 23/0482, issued on 2023-09-05
Table B11.1: Conditions for proper installation and additional advice for installation
Note: Driving rain resistance must be designed in accordance with the provisions given
in Annex B2 for fasteners with an interior part made of galvanized steel.
≤8 mm
rendering
thickness
ETICS
rendered
with
plaster
>8 mm
rendering
thickness
* External Thermal Insulations Composite Systems (ETICS) or rendered insulation with reinforced plaster which are
glued only or glued and mechanically fixed.
** ≥ 5 kPa is a guideline value that the thermal separation module can apply sufficient pre-tensioning force
in the insulation panel to ensure the compression of the sealing ring.
The values stated are to be understood as guideline values in order to give the user the highest possible
application safety.
RECA dimos anchor UNI-RT 12, RECA dimos anchor UNI-RT 16
Intended use
Conditions for proper installation and additional advice for installation
UNI-RT 12, UNI-RT 16
ETICS* with insulation panels made of
XPS Mineral wool,
EPS compression
strength ≥ 5 kPa**
Standard installation in accordance with annex B5, B6,
B7, B8, B9 and B10
Drill the hole through the insulation and in the base
material with a regular drill bit. Afterwards, enlarge
the hole in the plaster to d=26 mm by using e.g. a
wood drill bit.
wood fiber, raw wood fiber, raw
density density >230kg/m
≤230kg/m
3
and or compression
compression
strength
≤ 100 kPa
Drill the hole
through the
insulation and in the
base material with a
regular drill bit.
Afterwards, enlarge
the hole in the
plaster and
insulation to
diameter 26 mm to a
depth of 60 mm. For
this purpose a wood
drill bit may be
used.
3
strength
> 100 kPa
Annex B11