RECA dimos UNI-RT 12 Bedienungsanleitung Seite 21

Page 20 of 32 of European Technical Assessment no. 23/0482, issued on 2023-09-05
dimos anchor UNI-RT 12, dimos anchor UNI-RT 16: Installation instruction (in hollow brick)
RECA dimos anchor UNI-RT 12, RECA dimos anchor UNI-RT 16
Intended use
Installation instruction in hollow masonry
11. If the wall is uneven, the RECA dimos anchor UNI-
RT can be readjusted
The unevenness can,
for example, be lined with polyamide washers according to
DIN 9021 with a diameter of 37x13x3 mm
(Art.-No. 0421 012). The thermal separation module may be
unscrewed by a maximum of 3 mm using the
two-hole nut driver (Art. No. 0911 250 000). A resulting gap
should be sealed with a suitable sealant (e.g. S78).
A cover/sealing of the anchorage point is required when:
•
•
•
•
With thick plaster or hard insulating material, the drill hole
must be drilled out to a depth (length of the thermal
break module) of 26 mm.
the deflection under shear stress is
greater than 3 mm
the anchor is not perpendicular to
the plaster surface
the grain size or roughness of the
plaster is greater than 3 mm
the drill hole diameter in the plaster
is larger than 26 mm
Annex B10