Herunterladen Diese Seite drucken

Teka MDB-600 Bedienungsanleitung Seite 10

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Dear Customer,
Congratulations on your choice. We are
certain that this modern, functional and
practical device made with first rate qua­
lity materials will fully satisfy your require­
ments.
Please read all the sections in this INS­
TRUCTION MANUAL before using the
hood for the first time in order to obtain
maximum performance from the device
and avoid faults which may arise from inco­
rrect use as well as minor problem solving.
For optimal performance, the external duct
should not exceed FOUR METRES, have
more than two 90 ° angles and its diameter
should be at least Ø120.
Safety Instructions
•Disconnect the device before
performing any work on the in­
terior, e.g. during cleaning or
maintenance.
•The excessive accumulation of
grease in the hood and metal fil­
ters may cause dripping and fire
risks, therefore it is necessary to
wash the inside of the hood and
the metal filters at least once a
month.
•This device can be used by
children aged 8 and over and
persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowled­
ge, if they have been given su­
pervision or proper training in
the safe use of the device and if
they understand the dangers in­
volved. Children should not play
with the device. Cleaning and
maintenance should be perfor­
med by the user and not by un­
supervised children.
•Check that the power voltage
and frequency match those in­
dicated on the label located on
the inside of the hood. A suitable
earth must be connected (except
for Class II devices, marked with
on the technical data plate).
•For installation, a connection
method isolated from the fixed
installation should be incorpora­
ted, in accordance with installa­
tion regulations (adjusted to the
strength to be endured and with
a minimum opening between the
contacts of 3mm) under over­
voltage category III conditions,
for the emergency shutdown,
cleaning or light replacement. In
no event should the earth pass
through this switch. This switch
can be replaced with a plug if it is
accessible in normal use.
•If the power lead is damaged it
must be replaced by the manu­
facturer, its after­sales service or
by qualified personnel in order to
avoid potential danger.
•Air should not be extracted by
ducts used to expel fumes from
equipment powered by gas or

Werbung

loading