Initial Activation And Setting Up - Pyrexx Px-1C Gebrauchsanleitung

CAUTION
Possible property damage!
Over-tightening the screw may deform the
magnet carrier.
f Tighten the screw only so deep that
the magnet carrier is not deformed
or bulged.
(6) To ensure a safe hold of the device, tighten
the screw deep into the dowel so that it
closes flush with the magnet carrier.
Also in a drilling installation, you can
create an adhesive compound using
additional adhesive film, according to
vfdb 14/01 (Q) (see chapter "Adhesive
mounting according to EN 14604:2005/
AC:2008 and vfdb 14/01 (Q)" on page
54).
(7) Activate the device and set it up.
Observe chapter 6 "Initial activation and
f
setting up" on page 56.
(8) Position the device on the magnet carrier.
5 The magnet carrier is attached and the
device positioned on it.
56
6 Initial activation and setting
Always consider the following when activating
and setting up smoke alarm devices:
f Activate devices in a radio group one
f To prevent overlaying radio signals,
f Establish a radio group of at least 2 and
f Connect a maximum of 15 radio
f After activating the device, the splint
User Manual: PX-1C - Smoke Alarm Device with Radio Link
up
after another in their final installation
location.
keep a minimum distance of 2 to 3 m
between the devices.
a maximum of 15 smoke alarm devices
connected together.
groups together.
pin is used as a tool for triggering the
radio button, and must be kept readily
available in the vicinity of the device.