Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 Safety
Expertise in material selection and instal-
l
lation.
2.3 Safety information
n
Read the instructions carefully and in full
and follow the warning notices.
n
Store the instructions securely.
n
The Wallbox must be installed, connected
and commissioned by a qualified electrical
engineer in compliance with local regu-
lations and standards.
n
Only semi-public and private locations are
permitted.
n
Observe the information regarding the
assembly and installation location, see
Assembly and installation location
n
Observe the ambient conditions (tem-
perature and humidity, see
n
Only approved parts are to be used. Instal-
lation of damaged / soiled / contaminated
parts is not permitted.
n
Do not stick anything onto the Wallbox or
block it with objects.
n
Do not insert any objects into the Wallbox.
n
Do not place any objects on the Wallbox.
n
Avoid the Wallbox coming into contact with
liquids.
n
Do not install in potentially explosive loca-
tions.
n
Protect each installed Wallbox with a resi-
dual current circuit breaker (minimum
RCD type A).
n
Observe the required overvoltage and fault
current protection (RCD type A), see
nical
data.
n
No not use extension leads, cable drums or
multiple socket outlets.
n
Do not use adapters.
n
For version with socket: Protect the socket.
n
For version according to German official cali-
bration law: Do not detach, manipulate or
bypass the manufacturer's seal.
n
Do not make any modifications to the hou-
sing or the internal components of the Wall-
box.
n
Observe the national safety regulations.
n
Observe all local regulations for electrical
installations, as well as current fire pre-
vention and accident prevention regulations.
n
Persons with a cardiac pacemaker must
.
maintain a distance of at least 60 cm and
persons wearing a defibrillator a distance of
Technical
data).
at least 40 cm from RFID scanners, iden-
tifiable by the symbol on the front panel.
n
Ensure that symmetrical network operation
is guaranteed in 1-phase operation. The
detailed requirements regarding unbalanced
load regulations can be found in the respec-
tive country-specific requirements. See
ting the charging
Note
For information on whether the 1-/3-phase swit-
ching may be used with the vehicle, see the
vehicle manufacturer's documentation or contact
the vehicle manufacturer.
Note
eSystems MTG GmbH only accepts responsibility
Tech-
for the delivery condition of the Wallbox and for
work performed by the manufacturer's specialist
personnel.
Set-
current.
30
Werbung
