Volvo Wallbox selected Installationsanleitung Seite 31

1.2 Documentation concept and target
group
The assembly and installation instructions des-
cribe the mechanical and electrical installation of
the Wallbox and are aimed at electrical engineers
and specialist companies approved by the net-
work operator, who are responsible for instal-
lation and commissioning of the Wallbox. See also
Qualifications.
For information on other instructions available,
refer to the operating instructions.
Reading and storing the documentation
n Read the documentation carefully before
installation.
n The documentation must be securely stored
and handed over to the new owner in the
event of sale.
1.3 Means of representation
The following means of representation are used:
Means of Meaning
representation
Bold script Texts from the web app
within
running text
Blue italics Link to a related topic.
n Instruction that you have to
follow.
1. Instructions are numbered if a
series of multiple steps have
to be carried out.
29
2 Safety
2.1 Safety symbols
In these instructions, warning notices appear
before sequences of actions that involve a risk of
injury or damage. The measures described to pre-
vent the hazard must be adhered to.
Layout of warning notices
SIGNAL WORD
Cause of the hazard
Remedy
n Action 1
n Action 2
Warning sign draws attention to the hazard.
l
Signal word indicates the severity of the
l
hazard.
Cause of the hazard specifies the nature and
l
source of the hazard.
Remedy specifies how the hazard can be
l
averted.
Meaning of symbols
DANGER
Hazardous situation in which death or serious
injury will occur if it is not prevented.
WARNING
Hazardous situation in which death or serious
injury could occur if it is not prevented.
CAUTION
Hazardous situation in which minor to moderate
injury could occur if it is not prevented.
ATTENTION
Damage to equipment could occur.
Note
Useful tips and recommendations, as well as infor-
mation on efficient and fault-free operation.
2.2 Qualifications
WARNING
Risk of injury due to inadequately qualified
personnel.
This can cause serious injuries and damage to
equipment.
n Only trained and appropriately qualified per-
sonnel are to work on the Wallbox.
Note
All of the activities described in these
assembly and installation instruc-
tions may only be performed by a
qualified electrical engineer.
The electrical engineer must have the following
qualifications:
Based on training and experience, the ability
l
to identify risks and to prevent potential
hazards caused by electricity.
Professional qualifications entitling them to
l
perform work on electrical equipment.
Knowledge of the applicable standards and
l
regulations for all work on electrical equip-
ment.
Ability to evaluate measured results.
l
Knowledge of network installation tech-
l
nologies.
2 Safety