Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To start up the FB3000, apply power by plugging in
the terminal block for the power supply module.
Periodically inspect the wiring for signs of
deterioration.
Configuring the FB3000
You must install Emerson's Field Tools
configuration software (which includes
FBxConnect™) on your PC to configure the
FB3000 for use. Refer to the
Quick Start Guide
(part D301859X012) for
instructions on installing and using this software.
Resetting the FB3000
If you are experiencing problems that appear to
be software related, try resetting the FB3000.
Refer to the
Service and Troubleshooting
Emerson FB3000 RTU Instruction Manual
the
D301851X012) for specific instructions.
Note: You lose all configuration and log data
with a reset. If possible, make a backup of
configuration and log data before
attempting any type of reset.
www.Emerson.com/SCADAforEnergy
Emerson FB3000 RTU
chapter in
(part
Safe Use Instructions – Emerson FB3000 RTU
Replacing Parts in the FB3000
Refer to
Table 1
for a list of user-serviceable parts
and their respective field replacement guides.
Returning the FB3000
If you are experiencing problems that appear to be
hardware-related, verify the wiring. If you still
experience problems, contact your local sales office
for return authorization. To return the device:
1. Back up all configuration and data before
removing the device from process. Then remove
power from the device and remove all external
wiring.
2. Uninstall the device.
3. Place the device into a box safe for shipping or
storage.
Part D3018765X012
November 2023
5
Werbung
