Ocmis Irrigazione RAIN CONTROL 4 Bedienungs- Und Wartungshinweise Seite 42

ALARM MESSAGES
Alarm messages are displayed at the centre of the LCD
in case of machine malfunction.
Alarm message can be deleted from display by pressing
after having eliminated its cause.
Every alarm refers to the following codes:
1. Battery voltage below 8V
2. Short-circuit on external power supply
3. Litre counter error
4. Speed alarm
5. No pressure
6. End of work cycle
CHANGING PROGRAMME DURING OPERATION
RAIN CONTROL 4 allows you to change programmed working parameters even during
operation. Change parameters as follows:
1. The monitor displays machine winding status.
2. Press Prog : programmed priority is displayed.
3. Press + and - keys to set new value.
4. Press Prog to confirm and go back to machine winding status page.
The equipment will automatically set to new program and correct all parameters.
ADDITIONAL FUNCTIONS
Manual Function: this function allows you to manually pilot the turbine by-pass so as to check (with machine
running) the minimum and maximum speeds the machine can reach when engaging the various speeds of the
gearbox. It is possible to use the Manual Function in two ways:
1. Machine Stop Status.
2. Machine Winding Status.
3. Press Manual key
4. Press + to increase speed
or - to decrease it.
In this way you change turbine
by-pass opening or closing and
therefore the speed.
5. Press again Manual key to go
back to Machine Stop or Winding
Status page.
NOTE: Speed value is calculated and refreshed once a minute: to see the current speed you should then wait at least
1 minute.
MANUALLY ENTERING THE UNWOUND METRES ( ft ) OF HOSE
When hose is laid down with computer off or with limit switch tripped,
unwound metres of hose are not calculated. Manually enter unwound
Metres of hose as follows:
1. The machine should be STOPPED.
2. Press + and - keys at the same time. The number inside mt or ft
box will be flashing, then use + and - keys to enter unwound hose
length.
3. Press + and - keys at the same time to confirm.
Entered figure will no longer be flashing.
EN
36