Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CHOOSING THE WORK PROGRAM
Use + and - keys to choose the letter corresponding to the
wished work programme.
Press PROG to confirm and go to the page of set programme.
ZONE SPEED PRIORITY
Use + and - keys to increase or decrease set value.
Press PROG to confirm set value and go to Timers for Start/
Stop, Delayed Start, and then to Stop Status Page.
START AND STOP TIMER
Program start timer with trolley stopped, use + and - keys to set time, or leave
time to zero if you wish to have the machine start immediately.
If you wish the outlet valve or closing valve (option) to trip with a certain delay
at cycle end, use + and - keys to set wished time, or leave time to zero if you
wish to have the valve trip immediately at work end.
DELAYED START
Use + and - keys to enable or disable machine start at set time.
When activated, an X should be displayed in the suitable box,
it can be disabled with – key.
PAGE: STOP STATUS
In this position, if all operations have been performed correctly, press START
to start the work cycle.
PAGE: WINDING STATUS
Once START has been pressed, the work cycle starts and cycle end day and
time, hose winding speed, metres (ft) of unwound hose and machine flow rate
in l/min (G.P.M.) are displayed.
PROGRAMME "D" - ZONE SPEED
Up to 4 zones (speed) can be programmed on the same tube section.
1.
Zone D1: set for how many metres (e.g. 60) a certain speed is to be maintained (e.g. 20 mt/h).
2.
Zone D2: set for how many metres (e.g. 20) a certain speed is to be maintained (e.g. 20 mt/h).
3.
Zone D3: same as previous point.
4.
Zone D4: same as previous point.
It is important that when adding all metres set for the above zones, the total corresponds to the total metres of
unwound hose.
If only two zones are needed, such as D1 and D2, do not program zone D3 and carry on with next steps.
ANTICIPATED STOP
Programming the "area program" with priority speed "D" you can program the last area with speed 0, in this way the com-
puter will force the stop of the hose reel to the required unrolled meters.
To re-start the machine repeat the program and push "START"
With the option "anticipated stop" the calculation of working time is no more the final one but the time of the arrival at the
area with speed 0.
Programme D
EN
33
Werbung
