Ocmis Irrigazione RAIN CONTROL 4 Bedienungs- Und Wartungshinweise Seite 37

CHOOSING THE WORK PROGRAMME
Use + and - keys to choose the letter corresponding to desired
work programme.
Press PROG to confirm and go to the page of set program.
RAIN PRIORITY
Use + and - keys to increase or decrease set value in mm of
rain.
Press PROG to confirm set value and go to Irrigated Width.
Programme C with raingun
1) Put in the diametre of the nozzle fitted to the raingun
2)Put in the pressure registered by the pressure gauge
3)Put in method "M (measured) " or C (calculated)"
with reference to the irrigated strip :
- when putting in "M" the required width of the irrigated strip
must be set in the subsequent window
- when putting in "C" the width of the irrigated strip
will be shown automatically, being calculated by the compu-
ter
PROGRAM C SPRAY BOOM
1) Choose the structure of spray boom
2) Choose the nozzle
3) Choose pressure at the nozzle
4) Choose program « M » (measured) or « C » (calculated) for
the irrigated area :
with « M » must be set the width of the irrigated area required
with « C » will appear automatically the value of the calculated
irrigated area
PROG to continue programming
Programme C
EN
31