Scheppach HC500 Original Bedienungsanleitung Seite 28

Dispose of the old oil at a drop-off point for old oil.
To fill in the correct quantity of oil, make sure that the
compressor stands on an even surface. Fill new oil
through the oil filler opening (19) until it comes up to
the maximum level. This is marked with a red dot on
the oil level window (12) (Fig. 11). Do not exceed the
maximum filling quantity. Overfilling the equipment
may result in damage. Reinsert the oil sealing plug (15)
into the oil filler opening (19).
10.6 Cleaning the intake filter (Fig. 3, 12, 13)
The intake filter prevents dust and dirt being drawn in.
It is essential to clean this filter after at least every 300
hours in service. A clogged intake filter will decrease
the compressor's performance dramatically. Open the
screw (E) to remove the intake filter (2x).
Then pull off the filter cover (D). Now you can remove
the air filter (F). Carefully tap out the air filter, filter cov-
er and filter housing. Then blow out these parts with
compressed air (approx. 3 bar) and reinstall in reverse
order.
10.7 Storage
m Important!
Pull out the mains plug and ventilate the equip-
ment and all connected pneumatic tools. Switch
off the compressor and make sure that it is se-
cured in such a way that it cannot be started up
again by any unauthorized person.
m Important!
Store the compressor only in a dry location which
is not accessible to unauthorized persons. Always
store upright, never tilted! Oil may leak out!
10.7.1 Releasing excess pressure
Release the excess pressure by switching off the com-
pressor and using the compressed air which is still left
in the pressure vessel, e.g. with a compressed air tool
running in idle mode or with a blow-out pistol.
10.8 Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: belt, coupling
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
28 | GB
11. Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
Used batteries or rechargeable batteries that are not
installed permanently in the old appliance must be re-
moved non-destructively before disposal. Their dis-
posal is regulated by the battery law.
Owners or users of electrical and electronic devices
are legally obliged to return them after use.
The end user is responsible for deleting their personal
data from the old device being disposed of!
The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
Waste electrical and electronic equipment can be
handed in free of charge at the following places:
Public disposal or collection points (e.g. municipal
works yards)
Points of sale of electrical appliances (stationary and
online), provided that dealers are obliged to take them
back or offer to do so voluntarily.
Up to three waste electrical devices per type of device,
with an edge length of no more than 25 centimetres,
can be returned free of charge to the manufacturer
without prior purchase of a new device from the manu-
facturer or taken to another authorised collection point
in your vicinity.
Further supplementary take-back conditions of the
manufacturers and distributors can be obtained from
the respective customer service.
If the manufacturer delivers a new electrical appliance
to a private household, the manufacturer can arrange
for the free collection of the old electrical appliance
upon request from the end user. Please contact the
manufacturer's customer service for this.
www.scheppach.com
The packaging materials are re-
cyclable. Please dispose of pack-
aging in an environmentally
friendly manner.