Werbung
Verfügbare Sprachen
Verfügbare Sprachen
20
www.electrolux.com
sure the glass slides out of the
supports completely.
8. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install
the glass panel and the oven door. Do
the above steps in the opposite
sequence.
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
Make sure that you install the internal
glass panel in the seats correctly.
11. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
10.6 Replacing the lamp
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
The back lamp
1. Turn the lamp glass cover to remove
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
4. Install the glass cover.
A
Possible cause
The oven is deactivated.
The fuse is blown.
The lamp is defective.
WARNING!
Risk of electric shock.
The lamp can be hot.
cavity.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
it.
°C heat-resistant lamp.
Remedy
Activate the oven.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Werbung
