HP LaserJet MFP Betreiberhandbuch Seite 43

The information in the sender information fields on the Setup tab is
Note
updated the first time that the sender information is entered in the
sender information fields in the Default Settings dialog box. If the
default sender information is changed later, the sender information
fields on the Setup tab are not refreshed. The changes are saved,
but the information does not appear in the dialog box. To show the
new information, exit from the MFP Send Fax driver and then restart
the driver.
3
To set all of the default information at the same time, select the
Note
fax quality, notification, cover page, and preview settings and then
click OK.
Setting the fax quality
The fax quality setting defines the resolution that the MFP uses to
send the fax. The quality settings are as follows:
●
●
●
To set the fax quality, use the following steps:
1
ENWW
Click OK.
Standard: 200 x 100 dots per inch (dpi)
Fine: 200 x 200 dpi
Superfine: 300 x 300 dpi
On the Setup tab, click Edit Defaults.
Setting the fax quality 35