Replacing Wearing Parts - Fronius Opt/I Wf R Bedienungsanleitung

The retaining arm (3) must not touch the wirespool or the wire electrode.
Replacing wear-
ing parts
20
(1)
(2)
2 mm (0.079 in.)
NOTE!
(4) (3)
(5)
(5)
(1)
(2)
2 mm (0.079 in.)
4
5
6
7
1
(2) (1)
2
3
NOTE!
When screwing or unscrewing the shoe
(1) to/from the sensor (2), ensure that
the sensor cable is not twisted.
4
5
6
7
8
Unscrew the shoe (1) from the sensor
(2), ensuring that the gap between the
sliding surface of the shoe and the sur-
face of the sensor is 2 mm (0.079 in.)
Tighten nut (4)
Position the shoe (1) and sensor (2) on
the retaining arm (3) and tighten using
two screws (5)
Unlock the retaining arm (3) and ensu-
re that the shoe is touching the wire
electrode
Lift the retaining arm (3) and sensor
unit off the wirespool and lock in place
Undo screws (5) and take the shoe (1)
and sensor (2) off the retaining arm (3)
Undo the hexagonal nut (4)
Unscrew the shoe (1) from the sensor
(2)
Screw a new shoe (1) onto the sensor
(2), ensuring that the gap between the
sliding surface of the shoe and the sur-
face of the sensor is 2 mm (0.079 in.)
Tighten the hexagonal nut (4)
Position the shoe (1) and sensor (2) on
the retaining arm and tighten using two
screws (5)
Unlock the retaining arm (3) and ensu-
re that the shoe (1) is touching the wire
electrode