Teka GFG2 INOX Bedienungsanleitung Seite 21

extractor is used. Note that grease is deposited in the extractor
when cooking, whether it is switched on or not.
• We recommend the use of gloves and caution when cleaning the
inside of the extractor.
Repairs
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
• Do not switch on the extractor if the supply cord is worn or has
cuts or if there are signs of deterioration around the control
panel.
• If the LED module is malfunctioning, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
• If the extractor stops working or functions abnormally, unplug it
from the mains and contact the technical service.
•
Please contact the nearest Qualified Technical Assistance
Service for any repairs always using original spare parts. Repairs
and modifications carried out by others could damage the
extractor or cause it to malfunction and cause safety risks.
A Motor controls, three speeds:
Low
High
Intensive
B Light switch independent from motor
commands
C Lighting by means of LED lamp
figure 1, you will be able to control the
functions of the extractor.
Two achieve better extraction, we recommend
switching on the extractor a few minutes
before starting to cook (3 - 5 minutes) so that
-
D Filter located over cooking area, easily
withdrawn for cleaning
E Frame and filter support
F Possibility of incorporating activated
charcoal filter (fig.2)
G-H Anti return tabs to be located in the
outlet mouth, locating their ends in the
holes provided (fig.2).
the air flow is continuous and stable when
extracting the fumes.
Likewise, keep the extractor switched on for a
few minutes when cooking is complete to
allow all fumes and odours to be expelled.
EN
21