Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cutting Speed
The cutting speed is a function of:
Thickness and of material to be cut.
Value of set current. The current setting affects the quality of the cut edge.
Geometrical shape of the cut (whether straight or curved).
In order to provide indications on the most suitable setting, the following table was established, based on tests performed
on an automatic test-bench; the best results however can only be achieved from direct experience by the operator in his
actual working conditions.
MILD STEEL
Thickness
Current
(mm)
(A)
6
60
10
60
12
80
15
80
20
100
25
100
25
130
30
130
35
130
Electromagnetic Compatibility (EMC)
This machine has been designed in accordance with all relevant directives and standards. However, it may still generate
electromagnetic disturbances that can affect other systems like telecommunications (telephone, radio, and television) or
other safety systems. These disturbances can cause safety problems in the affected systems. Read and understand
this section to eliminate or reduce the amount of electromagnetic disturbance generated by this machine.
This machine has been designed to operate in an industrial area. To operate in a domestic area it is
necessary to observe particular precautions to eliminate possible electromagnetic disturbances. The
operator must install and operate this equipment as described in this manual. If any electromagnetic
disturbances are detected the operator must put in place corrective actions to eliminate these disturbances
with, if necessary, assistance from TEC.MO. s.r.l..
Before installing the machine, the operator must check the work area for any devices that may malfunction because of
electromagnetic disturbances. Consider the following.
Input and output cables, control cables, and telephone cables that are in or adjacent to the work area and the
machine.
Radio and/or television transmitters and receivers. Computers or computer controlled equipment.
Safety and control equipment for industrial processes. Equipment for calibration and measurement.
Personal medical devices like pacemakers and hearing aids.
Check the electromagnetic immunity for equipment operating in or near the work area. The operator must be sure
that all equipment in the area is compatible. This may require additional protection measures.
The dimensions of the work area to consider will depend on the construction of the area and other activities that are
taking place.
Consider the following guidelines to reduce electromagnetic emissions from the machine.
Connect the machine to the input supply according to this manual. If disturbances occur if may be necessary to take
additional precautions such as filtering the input supply.
The output cables should be kept as short as possible and should be positioned together. If possible connect the
work piece to ground in order to reduce the electromagnetic emissions. The operator must check that connecting
the work piece to ground does not cause problems or unsafe operating conditions for personnel and equipment.
Shielding of cables in the work area can reduce electromagnetic emissions. This may be necessary for special
applications.
STAINLESS STEEL
Speed
Thickness
(cm/min.)
(mm)
250
6
130
10
130
12
100
15
120
20
70
25
100
25
70
30
50
Current
Speed
Thickness
(A)
(cm/min.)
60
230
60
120
80
120
80
80
100
90
100
50
130
80
130
50
A-5
ALUMINIUM
Current
Speed
(mm)
(A)
(cm/min.)
6
60
10
60
12
80
15
80
20
100
25
100
25
130
PC 130 - 2010
300
170
180
120
130
80
120
Werbung
Inhaltsverzeichnis
