Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Controls and Operational Features
F D E G
A
B
A. Output Current Knob: Potentiometer used to set the
output current used during cutting. Refer to the
Technical Specification section for more information
about the machine rated current range.
B. Remote LED: This LED lights when the machine is
switched
the Remote Control Connector.
C. Display LED: Output current and Air pressure view
(use the switch "H" for selection).
D. Output LED: This LED lights up when the output
terminals of the power source are energized.
E. Gas Alarm LED: This indicator lit when the value of
the cutting torch air pressure falls below the
minimum level required.
F. Thermal LED: This LED lights up when the machine
is overheated and the output has been disabled.
This usually occurs when the duty cycle of the
machine has been exceeded. Leave the machine
on to allow the internal components to cool. When
the thermal LED light turns off, normal operation is
again possible.
G.
Cutting LED : This LED lights up during cutting.
H. Display Switch: Selection switch to display the
output current or the air pressure.
I.
Remote Control Connector: Connect here the
remote control unit. Refer to the picture below for
the functions related to each pin of the connector
(front view):
C
H
1.
OUTPUT 10Vdc @ 20mA max: Auxiliary
Power supply.
2.
INPUT 0-10Vdc: Output Current Adjustment.
3.
GROUND.
4.
INPUT: ENABLE Remote Control connecting
to GROUND.
5.
INPUT: Start power source active connecting
to GROUND.
6.
OUTPUT: Open collector signal, closes to GND
when the arc is transferred to the work.
Maximum signal rating: 12Vdc @ 20mA.
7.
N.C.
J.
Torch Connector: Connect here the cutting torch. The
torch connection to the power source is very easily
performed through a quick-connector carrying the
torch trigger circuit, the gas line and the torch power
cable.
K
Insert the torch connector into the
corresponding receptacle on the front panel.
Use ONLY the torch supplied with this
machine.
For a replacement refer to the Maintenance section
of this manual.
A-3
PC 130 - 2010
I
WARNING
J
Werbung
Inhaltsverzeichnis
